QMOBILE SMART ROCKET LITE (SPD9832E) 100% TESTED FLASH FILE | CM2 READ FILE
This guide explains how to use the Infinity CM2SP2 to flash the QMOBILE SMART ROCKET LITE (SPD9832E) firmware.
Requirements
- Setting up the Infinity CM2 - hardware dongle
- Download and install the CM2-SP2 module
- Install the Unisoc-Spreadtrum driver
- QMOBILE SMART ROCKET LITE (SPD9832E) flash file/firmware
- A good quality USB cable
-Laptop / Computer
How to unlock QMOBILE SMART ROCKET LITE (SPD9832E) with Infinity CM2SP2?
1.Run CM2SP2 as administrator (wait until the dashboard appears)
2. select CPU in cm2sp2
3. select sc9832E _ base and
4. select the model in cm2sp2
5. model sc9832E _EMMC_1GB_RS
6. click on the flasher tab to select flash file.
7. doubleclick on the blank field under Pac/Sc.
8.In the new window that appears, select the file to flash (pac / bin, or SPD_PROG).
9.Wait while the cm2 read firmware details.
10.Check or uncheck the checkbox for the file(partition) you want to flash.
11. under Flash Settings, check the boxes according to your destination **(if you are not sure what to check or uncheck, check all)**.
12. click on Flash
13. when you see "Waiting for device", turn off the device,
14.press and hold the start/boot button (volume up and down button)
15. and connect the device to the PC via USB cable.
16. The device should be detected
17. it should start flashing the device
18.You should see a "done" message when flashing is complete.
19.Disconnect the device and turn it on.
Important information
- If you are not using the loader version, you must use a hardware dongle to use this tool
- Avoid interrupting the flash process or the device may die.
- Backups are good, but flashing official/factory firmware is safer, especially on newer Android devices where it can verify images.
Video guide
DOWNLOAD FREE QMOBILE SMART ROCKET LITE (SPD9832E) 100% TESTED FIRMWARE AND WATH VIDEO FOR GUIDANCE
